Jump to content
Mechanical Engineering

Rogue One

Members
  • Content Count

    1
  • Joined

  • Last visited

  1. Hello everyone, I hope you're all well. I am trying to figure out what the bearing set up is in the photo attached. Please could I get any advice? As far as I can see, starting from left to right, the set up is: - A bearing end cap (I am confused, because it has a central tightening screw. Perhaps it's an adapted bar end plug for the bearing shaft?). - A pillow block bearing (welded to back support pad). - Bearing lock collar (out of view, but I have confirmed this viewing other videos). - Brass coloured bushing or sleeve? - Through hole plate welded to base frame. - Box section end and pipe within? Box section attaches to seat pad. - Through hole welded to base frame. - Brass coloured bushing or sleeve. - Bearing lock collar. - Pillow block bearing. - Bearing end cap. - Obviously, there is some sort of shaft running through the whole set up. Purpose of this set up: It joins the gym bench's back support and seat pads to allow them to adjust on the same hinge. Any help would be greatly appreciated. J
×
×
  • Create New...