Hello everybody, I'm new on this forum and I hope I will receive a good advice from you. I have an automatic station with some LVDT sensors for measuring some dimensions, specially diameters. The product is a gasoline pump, and the station is measuring the pilot body diameter, but this diameter is measured after our last flow operation, flange welding. Because of welding the temperature of pump is around 60°C. Maximum diameter : 34.976 Pump diameter on 60° : over 34.980 (oot) Pump diameter on ~30°: below 34.976( good part) I cannot modify the flow to be able to wait for the pumps to cool down and to measure them, so they need to be measured on 60° and to show the values like on ~30°. I placed a temperature sensor and i think with some generic formula(maybe with a coefficient) I can be able to solve the issue. Could you help me? Best regards!